30" Hardwired Power Strip - EPS-H03008NV1

Customer Reviews   Write a Review

Be the first to review this item and earn 25 Rakuten Super Points™

Product Overview

30" (0.76m) durable metal housing Power Strip|8 black vertical NEMA 5-15R receptacles. Outlet spacing: 3.07" / 78mm (center to center)|6 easily punched off Knockouts for cord exit on each side - on top, both sides, the bottom cover and both ends|Easy on and off back cover, and wires readily stripped for faster operation|ETL approved and listed (conforms to UL5 and CAN/CSA C22.2 No. 62)|Input/output voltage: 110-125V 60Hz, 15Amp, 1875VA full load|Measurement: L30 x W1.614 x H1.535" (762 x 41 x 39mm). |Mounting clips: 3/4" (19mm) spring steel clips|Mounting tabs: N/A on this model|Q'ty per carton: 18|Shipping time: Usually ships in 24 hours. Expedited shipping available, 3 day, 2 day and/or next day. Rates vary by items and zip code|This hardwired type power strip is good for installation in your kitchen, cabinet, on the rack and so on. Mount it where you want it to be. NO Power Cord and Plug on this unit|

Specifications

Manufacturer e-dustry inc
Mfg Part# EPS-H03008NV1
SKU 233384939
Features
1. WARNING
1a Installation must be done by an electrician or a professional
1b Never install this unit during thunder storm
1c This unit is for indoor use only, not intended for use in or around wet or potentially wet areas such as aquariums, saunas, showers and fountains
1d Risk of Electric Shock!
2. INSTALLATION: Before installation, you may need a 3/8" wire clamp connector (Romex Connector) and 3 wire connectors (terminal connectors)
2a Turn off power in the house
2b Decide where to place this unit
2c Choose the side you want the cord exit and mark on the Knockouts coin
2d Gently punch off the Knockouts coin marked earlier with the back of a screw driver or other tool handy
2e Unscrew the Back Cover off the power strip with a philips screw driver
2f Take out the plastic insulation sheet. Cut a hole on it to let the wires through. (If to use the bottom knockout on the back cover, no need for a wire clamp connector. Thus please ignore 2g, 2h and 2j below)
2g Install the 3/8" wire clamp connector in place. Tightening the big ring screw (inside the wall)
2h Run the wires through (the bottom cover if necessary, and then) the white plastic insulation sheet first, then the wire clamp connector, from the outside into the power strip
2i Match the color of the wires and secure the wire connection with proper wire connectors
2j Tighten the two pressure screws properly on the wire clamp connector
2k Place the plastic insulation sheet back in position in the power strip
2l Screw the Back Cover on
2m For power strip with mounting tabs: screw down the unit on the floor, wall or in your cabinet or on your rack
2n For power strip without mounting tabs: place the unit where needed, make marks where to install the clips, about 6" away from each end. Screw the clips down with screws provided. Then, snap the unit in on the clips
2o Turn electricity back on, you are ready to go"
loading
Sold Out
Sorry, you missed the deal!
This product is currently not available.
ADVERTISEMENT
Promotions & Offers (1)
  •  custom promo
    5% Back* Sitewide with Promo Code Rewardme *See page for details
ADVERTISEMENT
ADVERTISEMENT