APC Matrix-UPS 5000VA - MX5000PE

Customer Reviews   Write a Review

Be the first to review this item and earn 25 Rakuten Super Points™

Product Overview

The UPS is a high-power enhanced line interactive uninterruptible power source designed to provide clean, reliable AC power to computer, data handling, and telecommunications loads. Normally, the UPS operates "on-line" and provides power to the load derived from the input utility source. When operating on-line, the UPS continuously regulates the load voltage by compensating for voltage fluctuations occurring over a wide range on the utility. A multilevel transformer tap changing circuit provides this regulation while attaining extremely high levels of on-line efficiency. In response to the need to adjust the load voltage, the UPS temporarily operates the load from power derived from the battery while an appropriate transformer tap change is made. In the event of unacceptable line conditions, transfer of load power from the utility to the inverter occurs synchronously and is virtually seamless under all conditions. The voltage waveshape delivered during "on-battery" operation is a low distortion sine wave. Resynchronization and retransfer of load power to the utility is automatic upon recovery of the line voltage to within normal limits.

A complete UPS system consists of three module types. The UPS is comprised of an Electronics Unit (EU), mounted atop an Isolation Unit (IU). Numerous Battery Packs can be purchased and plugged together on-site to provide the desired run time. The EU is self-connecting to the IU when mounted and is secured in place with the turn of an oversized hand screw. The EU contains the UPS's microprocessor controls, inverter, battery charger, transfer and tap changing circuits, remote interfaces, and the user control and display panel. The IU contains the UPS's isolation transformer, EMI/RFI filtering and surge suppression circuits, bypass circuit, and the utility and load wiring interfaces. The Battery Packs are "daisy chained" pack-to-pack, and to the EU, using a heavy duty cable and lockable connector system. Intelligent communications between Battery Packs and the EU is provided via a flat cable terminated with modular plugs. Each Battery Pack contains four high capacity batteries and microprocessor controlled electronics for communications and for battery pack voltage and current monitoring.

Specifications

Manufacturer American Power Conversion
Mfg Part# MX5000PE
SKU 10131418
UPC 731304007272
UPC 14 00731304007272
Features
Maximum Battery Recharge Time 3 Hour
Backup/Run Time (Full Load) 10.20 Minute
Product Type Line-interactive UPS
Manufacturer Part Number MX5000PE
Manufacturer American Power Conversion Corp
Product Name Matrix-UPS 5000VA
Product Line Matrix-UPS
Brand Name APC
Package Contents User ManualSmart UPS signalling RS-232 cableCD with software
Weight (Approximate) 303 lb
Height 26.9"
Width 13.8"
Depth 17.8"
Input Voltage 220 V AC
Load Capacity (VA) 5000 VA
Receptacles 6 x NEMA L6-30R / 1 x NEMA 5-15R / 2 x NEMA L14-30R
Output Voltage 240 V AC
Limited Warranty 2 Year
Tech Specs
Backup/Run Time 0.17 Hour 3.75 kW Full Load
Battery Recharge Time 3 Hour
Batteries Maintenance-free Sealed Lead Acid
Interfaces/Ports 1 x DB-9 RS-232 Serial / 1 x USB
Modular Slots 1 x SmartSlot
Sound Emission 60 dB(A)
Altitude 0 ft to 10000 ft Operating / 0 ft to 50000 ft Non-operating
Humidity 0 to 95% Operating / 0 to 95% Non-condensing Non-operating
Temperature 32°F (0°C) to 104°F (40°C) Operating / 5°F (-15°C) to 113°F (45°C) Non-operating
Thermal Dissipation 900 BTU/h
Product Type Line-interactive UPS
Manufacturer Part Number MX5000PE
Manufacturer Website Address www.apc.com
Manufacturer American Power Conversion Corp
Product Name Matrix-UPS 5000VA
Product Line Matrix-UPS
Brand Name APC
Battery Management Intelligent Battery Management
Bypass Switch Automatic & Manual
Emergency Power OFF Yes
Alarm On Battery / Low Battery
Additional Information Automatic Voltage Regulation (AVR) Building wiring fault indicator Hot Swap Electronics LCD AlphaNumeric Display Overload Indicator Replace Batt Indicator Scalable Run Time User Replaceable batteries Control panel: Multi-function LCD status and control console Included Software: PowerChute Matrix-UPS Bundle Max Configurable Power: 5,000 VA Max Configurable Power: 3,750 Watts Efficiency at full load: 93% Output Voltage Distortion: Less than 5% at full load Output Frequency (sync to mains): 57-63 Crest Factor: up to 5:1 Input voltage range for main operations: 156-252(208)/176-282( 240V)V Typical backup time at half load: 27.8 minutes (1875 Watts) Replacement battery cartridge: (2) SMARTCELL Units per Pallet: 1.0 Transfer to/from on-battery: 1.5 ms maximum. Transfer occurs synchronous with the utility voltage phase Transfer to/from bypass: Transfers to and from bypass occur synchronously with the utility voltage phase. Transfers both to and from bypass mode occur in 0 mS typically Maximum load: 5000 VA, 3750 W @ 0.75 power factor On-line voltage regulation: ±5%. When "Auto" or "Low" utility failure sensitivity is selected by the user, the output voltage regulation may become relaxed to +5%, -12% On-line frequency regulation: 60 Hz, ±5% (synchronized to the utility) On-battery output voltage regulation: ±5% On-battery output frequency regulation: 60 Hz, ±0.1 Hz unless synchronized to utility frequency during utility brownout On-battery output voltage total harmonic distortion: < 5% Protection: overcurrent and short circuit protected, latching shutdown upon overload Isolation: Galvanic isolation, output neutral bonded to ground Normal mode EMI/RFI noise attenuation: 40 to 60 dB over 100 kHz to 30 MHz range Common mode EMI/RFI noise attenuation: 40 to 60 dB over 100 kHz to 30 MHz range Normal mode let-through: < 1% of applied ANSI C62.41 Category A or B ±6 kV test Common mode let-through: < 2% of applied ANSI C62.41 Category A or B ±6 kV test Nominal battery pack voltage: 48 Vdc Typical battery life: 3 to 6 years (depends upon number of discharge cycles and normal ambient temperature) Maximum number of Battery Packs: limited only by desired recharge time Electromagnetic immunity: IEC 801-2, 801-3, 801-4, 801-5; severity level III or IV
Package Contents User Manual Smart UPS signalling RS-232 cable CD with software
Certifications & Standards CE CSA per C22.2 FCC A UL 1778 CDC Class A verified
Dimensions 27" Height x 13.80" Width x 17.80" Depth
Weight (Approximate) 303 lb
Color Beige
Form Factor Rack-mountable
Power Cord/Cable 72"
Input Voltage 220 V AC
Voltage Handling ±5% Output
Output Voltage 120 to 240 V AC
Filtering EMI / RFI Filter
Load Capacity 5 kVA
Power Consumption 3.75 kW
Waveform Type Sine Wave
Input Voltage Range 208 V AC to 240 V AC
Receptacles 6 x NEMA 5-15R / 2 x NEMA L6-30R / 1 x NEMA L14-30R
Plug/Connector Type NEMA L6-30P
Standard Warranty 2 Year
loading
Sold Out
Sorry, you missed the deal!
This product is currently not available.
ADVERTISEMENT
Promotions & Offers (1)
  •  custom promo
    5% Back* Sitewide with Promo Code Rewardme *See page for details
ADVERTISEMENT
ADVERTISEMENT