Cisco WAP200E Wireless-G Exterior Access Point with Power over Ethernet - WAP200E

Customer Reviews   Write a Review

Be the first to review this item and earn 25 Rakuten Super Points™

Product Overview

The Cisco® WAP200E Wireless-G Exterior Access Point (Figure 1) lets you connect Wireless-G (802.11g) or Wireless-B (802.11b) devices to your wired network, so you can add PCs to the network without the need for additional cabling. This weather-resistant access point creates a "wireless bubble" in exterior spaces, such as patios and outdoor cafés. Power over Ethernet (PoE) support makes it easy to install, and you can create multiple basic service set identifiers (BSSIDs) that connect to individual VLANs to keep your traffic separated.

The Cisco WAP200E is also ideal for use as a bridge to connect remote areas. For example, it could be used to connect offices with a warehouse housed in a separate building, or to connect the buildings of a college campus. Installing one access point on each building provides connections at up to Wireless-G speeds - with no cable to run. The weather-resistant housing protects the access point and is lightning protected.

To protect your data and privacy, the Cisco WAP200E supports both Wired Equivalent Privacy (WEP) and the industrial-strength wireless security of Wi-Fi Protected Access (WPA), encoding all of your wireless transmissions with powerful encryption. The MAC address filter lets you decide who can access your wireless network, and advanced logging keeps you apprised of access attempts. Configuration is a snap with the web browser-based configuration utility. RangeBooster technology, a compatible add-on to standard Wireless-G, can nearly double the range of your wireless network and increase its throughput by up to 35 percent. Unlike ordinary wireless technologies that are confused by signal reflections, RangeBooster uses two smart receivers at each end to detect and decode reflected signals at distances where standard technologies give up. You'll find that "dead spots" in the wireless coverage area are reduced as well.

The integrated quality of service (QoS) features provide consistent voice and video quality on both the wired and wireless networks, enabling the deployment of business-quality voice over IP (VoIP) and video applications. Additional features such as multiple BSSIDs, wireless roaming, and auto-channel selection make the Cisco WAP200E ideal for your business.


Manufacturer Cisco Small Business
Mfg Part# WAP200E
SKU 204769925
UPC 745883578597
UPC 14 00745883578597
Product Guide Click Here for the Cisco Small Business Store
Lightning-protected, weather-resistant housing
10BASE-T/100BASE-TX Ethernet port, auto-sensing half/full duplex, and automatic medium dependent interface (MDI) and MDI crossover (MDI-X)
Built-in 6-dBi directional antenna with 1x2 multiple-input, multiple-output (MIMO) to increase coverage
Obtains power via 802.3af PoE from a PoE switch or power injector
Simplified web interface for installation and configuration
802.1X RADIUS authentication
Supports WEP, WPA Pre-Shared Key (WPA-PSK), WPA2-PSK, WPA Enterprise, and WPA2 Enterprise wireless security
Supports four BSSIDs and 802.1Q VLAN to service set identifier (SSID) mapping
Supports Simple Network Management Protocol (SNMP) and uses an intuitive web-based interface
Supports Wi-Fi Multimedia (WMM) wireless QoS
Supports wireless roaming based on 802.11F (Inter-Access Point Protocol [IAPP])
Offers access point, bridge mode, and repeater mode
Supports wireless security monitoring (working together with Cisco WMP200, WPC200, and WUSB200 adapter cards)
Supports wireless client isolation
Tech Specs
Standards: IEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u, IEEE 802.3af (PoE), 802.1p (QoS priority), 802.1Q (VLAN), 802.1X (security authentication), 802.11i ready (security WPA2), 802.11e ready (WMM and unsolicited automatic power save delivery [U-APSD]), 802.11F (wireless roaming)
Ports: 1 Ethernet, 1 external antenna
Buttons: Reset
Cabling type: Unshielded twisted pair (UTP) Category 5
LEDs: Power, Ethernet, Wireless
Operating system: Linux
Web user interface: Built-in web user interface for easy browser-based configuration (HTTP/HTTPS)
Static IP: Yes
Dynamic Host Configuration Protocol (DHCP) client: Yes
SNMP versions: 1, 2, and 2c
Event logging: Yes
Web firmware upgrade: Yes
Diagnostics: Flash, RAM, LAN, WLAN
Access point: Access point mode, point-to-point bridge mode, point-to-multipoint bridge mode, repeater mode
Spec/modulation: 802.11b/direct sequence spread spectrum (DSSS), 802.11g/orthogonal frequency division multiplexing (ODFM)
Data rates: 802.11b: 1, 2, 5.5, 11 Mbps; 802.11g: 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps
Channels: 11 North America, 13 Europe (ETSI and Japan) auto-channel selection
Number of internal antennas: 2 at 6 dBi (directional)
Antenna connector type: Reverse polarity female N-type
Detachable antenna: Yes (sold separately)
RF power (Effective Isotropic Radiated Power [EIRP]): 802.11g: typical 16.5 dBm, 802.11b: typical 17 dBm
Antenna gain: Internal antenna: 6 dBi
Adjustable power: Yes
Receiver sensitivity: 802.11g: 54 Mbps at -65 dBm, 802.11b: 11 Mbps at -85 dBM
WEP/WPA/WPA2: WEP, WPA-PSK, WPA2-PSK, WPA Enterprise, WPA2 Enterprise
Connection control: Wireless connection control: MAC based
SSID broadcast: SSID broadcast enable/disable
802.1X: IEEE 802.1X support
Wireless client isolation: Wireless client devices can be isolated from each other either within an SSID or between 2 SSIDs; both isolation modes can be enabled at the same time.
Web-based utility access control: HTTP/HTTPS, wireless client web GUI access control
WEP bitsL: 64, 128
WPA bits and parameters: 128 - Temporal Key Integrity Protocol (TKIP)/Advanced Encryption Standard (AES)
WPA2 bits and parameters: 256 - AES
SSID broadcast on/off: Yes
Client isolation: Yes
MAC-based wireless connection control: Yes
Wireless web GUI access on/off: Yes
Dimensions: 6.42 x 8.07 x 2.17 in.
Unit weight: 2.47 lb (1.121 kg)
Mounting options: Industrial-strength, weather-resistant housing, lightning protection for outdoor enclosure, ceiling or wall mountable
Power: 48V DC; Maximum power draw: 4.8W
PoE in: Yes
Certification: FCC, IC,CE
Operating temperature: -4º to 140ºF (-20º to 60ºC)
Storage temperature: -4º to 140ºF (-20º to 60ºC)
Operating humidity: 5% to 95%, noncondensing
Storage humidity: 5% to 95%, noncondensing
Minimum Requirements:
802.11b or 802.11g wireless adapter with TCP/IP installed per PC
Switch/router with PoE support or PoE injector
Web-based configuration: Java-enabled web browser
Product Warranty: 3-year limited hardware warranty with return to factory replacement and 90-day limited software warranty

More Buying Options

Seller Infomation Price & Shipping  
buyoo - Trusted Lowest Price $472.00 + free shipping
Condition: Brand New
In Stock

Usually ships in 1 to 2 business days
Add to Cart
Racks4server $490.24 + $9.26 shipping
Condition: Brand New
In Stock

Usually ships in 1 to 2 business days
Add to Cart
$472.00 + free shipping
$571.00 You save $99.00 (17%)
Earn 472 ($4.72) Rakuten Super Points™
What are Rakuten Super Points™?
Get rewarded when you shop! Earn 1 point per dollar spent. That's like getting cash back on every purchase. Easy to see matured points in checkout. Use points just like cash.
Learn More
Condition: Brand New
In Stock. Usually Ships in 1 to 2 business days
Please select an option to buy
Add to Cart

What is a Marketplace and Shop Owner?
  • Our marketplace is a platform where approved third-party retailers (Shop Owners) can sell their products
  • Items are sold and shipped by Shop Owners
  • Your credit card and personal information remain secure; meets all PCI Security Standards.
  • Purchases can only be returned to the Shop Owner
  • All purchases receive Rakuten Super Points™
Promotions & Offers (1)
  •  custom promo
    7% Back on Lifestyle with Promo Code REWARDME at Checkout - Ends 10/14/15 *See page for details