EnGenius EAP350 High-Power 802.11n 2.4GHz Wireless Indoor AP/WDS/Repeater with Gigabit Ethernet Port

Tech Specs

	Hardware:
	MCU/RF: AR7242 + AR9283
	Memory: 32MB
	Flash: 4MB
	Physical Interface: LAN:
	1 x 10/100/1000 Gigabit Ethernet RJ-45
	Reset Button
	Power Jack
	LEDs Status
	Power/Status
	LAN (10/100/1000Mbps)
	WLAN (Wireless connection)
	Power Requirement:
	Power Supply: 90 to 240 VDC ± 10%, 50/60 Hz
	Active Ethernet (Power over Ethernet, IEEE802.3af)
	48 VDC/0.375A
	Device: 12V/1A
	RF Specifications
	Wireless Standard: IEEE802.11 b/g/n
	Frequency: 2.400 ~ 2.484GHz (b/g/n)
	Modulation Technologies: OFDM: BPSK, QPSK, 16-QAM, 64-QAM
	DBPSK, DQPSK, CCK
	Operating Channels: 11 channels
	Transmit Power:
	802.11b(2.412 ~ 2.472 GHz)
	29 dBm @ 1Mbps
	29 dBm @ 2Mpbs
	29 dBm @ 5.5Mbps
	29 dBm @ 11Mbps
	802.11g(2.412 ~ 2.472 GHz)
	29 dBm @ 6Mbps
	29 dBm @ 9Mbps
	28 dBm @ 12Mbps
	28 dBm @ 18Mbps
	24 dBm @ 24Mbps
	24 dBm @ 36Mbps
	23 dBm @ 48Mbps
	23 dBm @ 54Mbps
	802.11n(2.412 ~ 2.472 GHz)
	26 dBm @ MCS0/MCS8
	26 dBm @ MCS1/MCS9
	25 dBm @ MCS2/MCS10
	25 dBm @ MCS3/MCS11
	24 dBm @ MCS4/MCS12
	24 dBm @ MCS5/MCS13
	23 dBm @ MCS6/MCS14
	23 dBm @ MCS7/MCS15
	Receiver Sensitivity:
	802.11b (2.412 ~ 2.472 GHz) best = -98 dBm
	802.11g (2.412 ~ 2.472 GHz) best = -93 dBm
	802.11n (2.412 ~ 2.472 GHz) best = -93 dBm
	Antenna: Embedded omnidirectional antenna (Diversity support)
	Antenna Gain = 5 dBi
	Software Specifications
	Topology: Infrastructure/Ad-Hoc
	Operation Mode: Access Point/WDS/Repeater
	Multiple BSSID: Supports up to 4 BSSIDs
	LAN IP (check validity and DHCP server IP range) MAC
	DHCP range, lease time, client list
	VLANs: Supports 802.1q (up to 4 VLANs)
	SSID to VLAN mapping
	Spanning Tree: Supports 802.1d Spanning Tree Protocol
	Wireless mode: 11b/11g/11n
	Channel selection (setting varies by country)
	Channel bandwidth (Auto, 20MHz, 40MHz)
	Transmission rate: 11n only, 11b/g/n mix, 11b only, 11b/g, 11g only
	VPN: VPN pass-through (PPTP, L2TP, IPSEC)
	QoS: WMM
	WPS: Software only
	Security:
	WEP Encryption - 64/128 bit
	WPA Personal (WPA-PSK using TKIP or AES)
	WPA Enterprise (WPA-EAP using TKIP)
	802.1x Authenticator
	SSID broadcast enable/disable
	MAC Address Filter (AP mode)
	WLAN L2 isolation (AP mode)
	Wireless STA (Client) connected list (Idle/Connection Time, Pkt statistics)
	Management
	Tx Power Control: Adjust transmit power by dBm
	Configuration: Web-based configuration (HTTP)/Telnet
	Telnet Server: CLI
	Firmware Upgrade: Upgrade firmware via web browser
	Administrator Setting: Administrator Username & Password change
	Reset Setting:
	Reboot (press 1 second). Reset to Factory Default (press 10 second)
	System Monitoring: Status Statistic and Event log
	SNMP V1 , V2c
	MIB: MIB I , MIB II(RFC1213) and Private MIB
	Traffic Measurement: Per interface
	Auto-channel Selection: Automatically selecting least congested channel
	Bandwidth Measurement: IP range and bandwidth management
	Backup & Restore: Save & restore settings through Web interface
	Diagnosis: IP pinging statistics
	Environment & Physical
	Temperature Range:
	Operating: 0 to 50° C (32° to 122° F)
	Storage: -20 to 60° C (-4° to 140° F)
	Humidity (non-condensing):
	Operating: 90% or less
	Storage: 90% of less
	Dimensions:
	Diameter: 4.73” (120mm)
	Height: 1.97” (50mm)
	Weight: 0.62 lb. (280g)
	Certifications: FCC, CE, IC

BloomReach Content

EnGenius EAP350 High-Power 802.11n 2.4GHz Wireless Indoor AP/WDS/Repeater with Gigabit Ethernet Port

Product Details:

Rakuten