Be the first to review this item and earn 25 Rakuten Super Points™
Transition Networks' 100BASE-TX to 100BASE-FX Media Converter is available in both slide-in-module form factors; making cost-effective integration of twisted pair and fiber optics in Fast Ethernet networks easier than ever before.
Operates under heavy traffic loads without excess heat, so there is no need for a failureprone internal fan. Round trip delay of only 40 bit times - far below the Class II rating of 92 bit times. AutoCross technology eliminates an entire category of network troubleshooting by automatically matching crossed and uncrossed cables to the appropriate connection. The twisted pair port is instantaneously configured to the correct MDI or MDI-X configuration. Only Transition Networks guarantees compatibility with any 10/100-compliant port. This feature allows you to force the proper port configuration through an external switch on the converter; unlike competitive products that ship in auto-negotiation mode and may require both hardware and software configuration. Automatically detects and reports loss of link on a connection using Link Pass Through. This feature allows the equipment at the remote end of a link failure to "see" this failure and respond with corrective actions, such as Spanning Tree fail-over links, proprietary trunking links, or failure reports through SNMP or RMON procedures built into the switch, router or hub. Automatically detects faults in a link using Far End Fault. Ensures that link failures are reported properly to all devices on the network so that network problems can be diagnosed and corrected quickly. The converters will also automatically re-establish link when connected to two 10/100 auto-negotiating switches if link is lost. With other manufacturers' converters the user must intervene to reestablish link. Transition Networks conversion products will pass PAUSE signaling unhindered; allowing devices which are pause enabled to operate properly. Switches: SW1: Auto-Negotiation On/Off SW2: Pause TX On/Off SW3: LPT On/Off SW4: FEF On/Off Jumpers: Jumper Block 1: Auto Cross enable Fiber Optic Connector: Min TX PWR: -19.0 dBm Max TX PWR: -14.0 dBm RX Sensitivity: -30.0 dBm Max In PWR: -14.0 dBm Link Budget: 11.0 dB
Certifications & Standards
IEEE 802.3 UL listed FCC Class A EN55024 EN55022 Class A CE Mark
Fiber Optic Connector: Min TX PWR: -19.0 dBm Max TX PWR: -14.0 dBm RX Sensitivity: -30.0 dBm Max In PWR: -14.0 dBm Link Budget: 11.0 dB
100Base-TX / 100Base-FX
3" Height x 3" Width x 4.70" Depth
Fast Ethernet / SNMP / RMON
Additional Warranty Information
Effective for Products Shipped May 1, 1999 and After. Every Transition Networks' labeled product purchased after May 1, 1999 will be free from defects in material and workmanship for its lifetime. This warranty covers the original user only and is not transferable. This warranty does not cover damage from accident, acts of God, neglect, contamination, misuse or abnormal conditions of operation or handling, including over-voltage failures caused by use outside of the product's specified rating, or normal wear and tear of mechanical components. If the user is unsure about the proper means of installing or using the equipment, contact Transition Networks' free technical support services.
Sorry, you missed the deal!
This product is currently not available.
Promotions & Offers (1)
5% Back* Sitewide with Promo Code Rewardme
*See page for details